Solution: Ensure the dryer is plugged in, the circuit breaker hasn’t tripped, and the door is securely closed. If it still won’t start, check the door switch, start switch, and thermal fuse. Replace faulty parts as needed.

Solution: Check the heating element, thermal fuse, and cycling thermostat. Replace any defective parts. Also, ensure the dryer is set to the correct heat setting.

Solution: Clean the lint filter and check for vent blockages. Make sure the vent hose isn’t kinked or crushed. Inspect the moisture sensor and replace if faulty.

Solution: Inspect drum rollers, idler pulley, and drive belt for wear. Replace noisy or damaged components. Remove any foreign objects from the drum.

Solution: Check the drive belt and motor. Replace a broken belt or faulty motor. Inspect drum rollers for wear and replace if necessary.

Solution: Clean the vent and lint filter to prevent overheating. Check the cycling thermostat and thermal fuse. Replace defective components as needed.

Solution: Test the timer and control board. Replace any faulty parts. Make sure the start button isn’t stuck.

Solution: Check the power cord, outlet, and circuit breaker. Replace blown fuses and repair wiring issues as needed.

Solution: Inspect the door latch, hinges, and strike. Replace any worn or broken parts to ensure a secure closure.

Solution: Clean out lint buildup from the lint trap, vent, and drum. Remove any foreign objects. If the smell persists, check for electrical issues.

Solution: Clean the vent and lint filter. Inspect the moisture sensor and heating element. Replace faulty components as needed.

Solution: Check for blocked vents and clean them. Test the cycling thermostat and thermal fuse. Replace defective parts to prevent overheating.

Solution: Refer to your dryer’s manual for code meanings. Error codes may indicate sensor, control board, or heating issues. Address the specific problem or consult a technician.

Solution: Test the timer and control board for faults. Replace defective parts. Make sure the start button isn’t stuck.

Solution: Check for loose parts, worn bearings, or foreign objects in the drum. Replace or tighten parts as needed.

Solution: Inspect the drive belt, motor, and drum rollers. Replace broken or worn components to restore tumbling.

Solution: Clean the lint trap and exhaust vent. Make sure the vent hose isn’t crushed or blocked. Replace damaged hoses as needed.

Solution: Check for electrical shorts, faulty wiring, or overloaded circuits. Replace defective components and consult an electrician if needed.

Solution: Inspect the start switch, belt switch, and door switch. Replace any faulty switches to restore operation.

Solution: Avoid over-drying, use fabric softener, and promptly remove clothes after the cycle ends. Separate synthetic fabrics to reduce static.