Solution: Make sure the washer is plugged in, the circuit breaker hasn’t tripped, and the door or lid is securely closed. If it still won’t start, check the lid switch and control board. Replace faulty parts as needed.

Solution: Check for clogs in the drain hose or filter. Clean out any debris. If the pump is faulty, it may need to be replaced.

Solution: Unbalanced or overloaded loads can stop spinning. Try redistributing clothes or reducing the load. If that doesn’t help, check the lid switch, drive belt, or motor coupling.

Solution: Inspect hoses and connections for cracks or looseness. Replace worn door gaskets or seals. Tighten hose connections and replace damaged hoses.

Solution: Level the washer and ensure it’s on a stable surface. Check for worn shock absorbers, suspension rods, or drum bearings and replace as needed.

Solution: Check water supply valves and hoses for kinks or blockages. Clean inlet screens. If the inlet valve is faulty, replace it.

Solution: Run a cleaning cycle with washer cleaner. Wipe down the door gasket and detergent drawer. Leave the door open between washes to prevent mildew.

Solution: Check drain pump and spin cycle settings. Inspect the drive belt and replace if loose or broken. Avoid overloading the washer.

Solution: Wait a few minutes after the cycle ends. If still locked, unplug the washer for 5 minutes. If the door lock is faulty, it may need replacement.

Solution: Refer to your washer’s manual for code meanings. Codes often indicate issues with water supply, drainage, or sensors. Address the specific problem or consult a technician.

Solution: Test the water level pressure switch and hose. Replace faulty switches or hoses as needed.

Solution: Clean the detergent drawer and dispenser. Use the correct detergent and avoid overfilling. Replace the dispenser if it’s broken.

Solution: Clean the drum, gasket, and detergent drawer regularly. Use the proper amount of detergent and run regular cleaning cycles.

Solution: Check for power interruptions, unbalanced loads, or faulty door locks. Inspect the timer or control board if the problem persists.

Solution: Use high-efficiency (HE) detergent and measure carefully. Too much detergent can cause over-sudsing and drainage issues.

Solution: The drain hose may be installed too low or without an air gap. Adjust the hose height and check for siphoning issues.

Solution: Inspect the agitator, drive belt, and motor coupling. Replace worn or broken parts as needed.

Solution: This may be due to a faulty timer or control board. Try resetting the washer. If it’s still stuck, replace the faulty part.

Solution: Check your home’s water heater and supply. Inspect the inlet valve and temperature selector switch. Replace if necessary.

Solution: Make sure the washer is level and all feet are firmly on the floor. Replace worn suspension springs or add anti-vibration pads if needed.