Solution: Ensure the appliance is plugged into a working outlet. Check the power cord for damage and replace if needed. Let the unit cool if it overheated. If it still won’t start, check the motor brushes or fuse and replace as needed.

Solution: Inspect the speed control plate or board for damage or loose connections. Replace the speed control board or adjust the control knob as needed.

Solution: Lubricate the gears if dry. If noise persists, inspect for worn gears or bearings and replace as needed.

Solution: Replace old or separated gear lubricant. Check for worn or misplaced gaskets and replace if necessary.

Solution: Let the unit rest to cool down. Overheating can cause automatic shutoff. If the problem persists, inspect the motor, brushes, and wiring.

Solution: Check for air pockets around the blade and use a tamper or add liquid. Inspect the drive coupling and replace if stripped or damaged.

Solution: Inspect the gears and transmission for wear. Replace worn gears or adjust the beater height as needed.

Solution: Adjust the beater or blade height using the adjustment screw or the dime test. Ensure attachments are properly fitted and bowl is aligned.

Solution: Secure the hinge pin and tighten the locking screw under the mixer. Adjust attachment height if needed.

Solution: Allow the appliance to cool down before restarting. Avoid overloading and use short bursts for tough mixtures.

Solution: Run the mixer regularly to keep grease distributed. If leaking persists, regrease the gears or replace worn gaskets.

Solution: Check and tighten the blade assembly and jar base. Replace worn gaskets or seals if leaking continues.

Solution: Stop use immediately. Let it cool down. Inspect for overloaded motor, worn brushes, or failing wiring and replace as needed.

Solution: Check for worn or damaged attachment hubs. Tighten or replace as necessary. Clean attachment fittings regularly.

Solution: Inspect the bowl lift mechanism for misalignment or loose screws. Lubricate and tighten as needed.

Solution: Blender may have overheated or gone into sleep mode. Let it cool, then restart. Check for stuck items in the blade area and clear them.

Solution: Turn off the blender, remove the jar, and check for obstructions. Reinstall the jar and restart. If error persists, consult the manual.

Solution: Check for electrical shorts or overloaded outlets. Replace damaged cords or consult an electrician if needed.

Solution: Clean the control panel. If unresponsive, inspect and replace faulty switches or control boards.

Solution: Refer to your appliance manual for code meanings. Error codes often indicate issues with sensors or control boards. Address the specific problem or consult a technician.